TYPE
Vehicular Slide Gate Operator

CLASS OF OPERATION
Class I, II, III, IV

INPUT POWER
110-120 VAC, 60 HZ, Single Phase
220-240 VAC, 60 HZ, Single Phase

CURRENT DRAW 1/2 HP
5.4 Amp @ 115 VAC
2.8 Amp @ 230 VAC

CURRENT DRAW 1 HP
7.0 AMP @ 115 VAC
3.5 Amp @ 230 VAC

MOTOR
1/2 HP 60 cycles / hr.
1 HP 60 cycles / hr.

MAXIMUM GATE WEIGHT
1000 lb. (453 kg.) 1/2 HP
1500 lb. (679 kg.) 1 HP

MAXIMUM GATE LENGTH
30 ft. (9.2 m) 1/2 HP
45 ft. (13.7 m) 1 HP

OPERATING TEMPERATURE
-140ºF - 145ºF (-40ºC - 62ºC)

SPEED
Approximately 1 ft. (.3 m) / sec.

CHAIN
#40 Roller Chain Standard

ENTRAPMENT PROTECTION
Primary - Inherent (Type A)
Secondary - Provision for:
contact sensor (Type B1) and non-contact sensor (Type B2)

GATE RELEASE
Fail Safe - Standard
Fail Secure - Optional Factory Install

DIMENSIONS
Height: 24 in. (600 mm)
Width: 15 in. (375 mm)
Depth: 16.5 in. (412.5 mm)

WEIGHT
Approximately 125 lb. (56.5 kg.) to 185 lb. (83.7 kg.) depending on options selected.

LISTINGS
ETL Listed

NOTE: Use of this product is limited to vehicular slide gates only.  This product must never be used to operate any gate that is intended for pedestrian use.
FEATURES
  • Electronic, automatically adjusted limit settings (no mechanical limit switches required).
  • Mechanical and electronic inherent entrapment sensing system operable in both the open and close direction.
  • Automatic close timer is adjustable from 1 to 23 seconds.
  • Two ports for plug-in loop detectors.
  • Two 110 volt convenience outlets.
  • Built-in reset switch.
  • Partial open feature opens gate to 14 ft (4.3 m)
  • Special Anti-Tailgate loop function helps prevent vehicles from gaining entry by tailgating.
  • Gate Tracker™ reporting feature sends gate operator data to a companion DoorKing access control system.
  • Optional Battery Back-Up drive system opens gate automatically, or on command, during power outages