DoorKing Model 6050

TYPE
Vehicular Swing Gate Operator
CLASS OF OPERATION
Class I

INPUT POWER
110-120 VAC, 60 HZ, Single Phase
4.3 Amp @ 115 VAC (typical)

MOTOR
1/3 HP Intermittant duty cycle

MOUNTING
Pad or post mounted. Specify which at time of order.

MAXIMUM GATE WEIGHT
400 lb. (181 kg.)

MAXIMUM GATE LENGTH
10 ft. (3 m)

OPERATING TEMPERATURE
-140ºF - 145ºF (-40ºC - 62ºC)

SPEED
90º in approximately 10 seconds

ENTRAPMENT PROTECTION
Primary - Inherent (Type A)
Secondary - Provision for:
non-contact sensor (Type B2)

GATE RELEASE
Fail Safe - Clutch can be overridden. A keyed release is also provided.

DIMENSIONS
Height: 9.5 in. (237.5 mm)
On pad pedestal: 19.5 in. (487.5 mm)

Width: 13.25 in. (331 mm)
Depth: 23 in. (575 mm)

WEIGHT
Approximately 110 (50 kg.) to 140 lb. (63.5 kg.) depending on mounting option selected.

LISTINGS
ETL Listed

NOTE: Use of this product is limited to vehicular swing gates only. This product must never be used to operate any gate that is intended for pedestrian use.

Shown in pad mount configuration.

FEATURES

	Electronic, automatically adjusted limit settings (no mechanical limit switches required).
	Mechanical and electronic inherent entrapment sensing system operable in both the open and close direction.
	Automatic close timer is adjustable from 1 to 23 seconds.
	Two ports for plug-in loop detectors.
	Built-in reset switch.
	Gate overlap feature starts the master operator 1-2 seconds prior to the slave operator.
	Magnetic lock output provided for direct connection of mag locks to the circuit board.
	Tamper protect feature causes motor to run in the close direction if an attempt is made to force the gate open.
	Gate Tracker™ reporting output sends gate operator data to a companion DoorKing access control system.